Name:Water Heater Thermostat Model:999795 Specifications. Input voltage:220V Power: 3KW Current:13.6A Frequency: 50/60Hz Size: 180 125 125mm Phase parameters: single phase Intake: 50mm, outlet: about 32mm Heating range: About 12m³ This thermostat is specifically designed for the hot tub, the thermostat is installed in the pipeline jacuzzi.
When adding hot water bath, start the pump, the thermostat automatically heat insulation work, so the water temperature bath maintained at 39 degrees Celsius, give your Jacuzzi to create a more comfortable environment. The initial set temperature settings: Thermostat equipped with ultra-high temperature protection thermostat switch, thermostat to limit overheating and protect users against danger, however, users should be done after the installation is complete, the first under the premise of safety checks to ensure that the operation of the thermostat's normal function, By using the tub filled with water to a suitable level and start the system automatically checks and let the system run until the thermostat temperature stabilized at the highest level and display lights go out, use an accurate thermometer to measure the water temperature should be at 40 °C Thermostat operation is fully automated, clockwise, the heating is on, indicator light, temperature reaches a preset temperature, will remain at that temperature. Heating rate: The thermostat can be maintained within a temperature not exceeding 40 °C (104 °F) range. If cold water is started, will be 6 8 °C / h elevated temperatures.Automatic heating: Thermostat will first reach the preset temperature, then stop working until the temperature dropped a few degrees, the thermostat automatically turns on. Ultra-high temperature protection switch and reset button: Ultra-high temperature (over 49 °C), ultra-high temperature switch will automatically trip (power off). Note: Thermostat outlet to the bath tub in the middle of the pipe or valve or check valve can not be installed. Operating voltage: AC220V 50HZ / 60HZ Output load: 220V AC Power: 11 KW Working environment: -10 50 , RH?
90% Control range: -45 80 Resolution: 1 Accuracy: ± 1 Input signal: one road measure temperature sensor, 20K X 1.5m Machine size: 445 x 345 x 102mm/17.52 x 13.58 x 4.02inch Outer hole size: 42mm/1.65inch Inner hole size: 38mm/1.5inch Before using the installation requirements: 1. The power supply voltage and the voltage marked on the machine to be consistent, deviation of supply voltage and the rated voltage is not more than ± 10%. The sensor should maintain an appropriate distance from the power line, avoid contact or close. The strict distinction between sensors, power lines and the output relay interface. Note: This can only be used in pools around 8-10 cubic meters.
Package Included: 1 x Swimming Pool Electric Water Heater. International buyers please note: a. The item "3/11KW Swimming Pool SPA Hot Tub Electric Water Heater Thermostat Heating 220V" is in sale since Wednesday, July 18, 2018. This item is in the category "Home & Garden\Yard, Garden & Outdoor Living\Pools & Spas\Pool Equipment & Parts\Pool Heaters & Solar Panels".The seller is "anglestore" and is located in Altadena, California. This item can be shipped to United States, Canada.